Before the interior of the weaving shop which houses the Draper loom can be started an attached 15′ x 20′ storage area needs to be completed. Two walls are now finished and a third insulated today. The ceiling needs to be put up after the metal is put on the long outside wall (right) and the centre wall is done. After this then storage units need to be built, items put in, and then the work on the area of the Draper and work tables can begin. Work on this goes along as the weather is rainy outside…usually at least a few hours early every morning.
Board and batten construction involves placing lumber – usually one inch thick – vertically one next to another and then placing a smaller size board over the crack between the two. Lumber will shrink over time so what was once tight will invariably open up. Insulating the shop that houses our Draper Model D requires that the battens be drawn tight to the board over their entire length. A nail gun does this very well due to the speed at which it drives a nail, instantly snugging the two together. With farming done insulation of our workshop, which was built around the Draper, is next on the agenda.
A yarn ball or cone caddy/holder allows you to place a center-pull ball on top of the wooden stake so that as you load your loom the yarn cake/cone feeds as you go along. Buying a used loom you often get all sorts of other paraphernalia: books, magazines, yarns, winders of all sorts, etc.. This came with our 90″ Leclerc loom. It needs the addition of a disc that sits on top of the base, between it and the ball/cone, and can spin as required as the yarn is removed. I will need to make one of these as it is missing…
This 90″ Leclerc loom had its original home in Letellier, Manitoba. Settled in 1879 its first residents came from Quebec and the USA at the invitation of Father Lacombe. This loom was used by two ‘sisters’ (biological or religious meaning not clear) to make vestments, altar cloths, and other church-related items.
While loading the 90″ loom to bring it home there were extra pieces that did not match the loom. While unloading I set these aside. It did not take long to realize that these were the parts to a vertical warping mill. It is built by Leclerc and needs to be refurbished but it is in great shape. It now retails for $750 but came free with the 90″ loom…
Leclerc’s 90″ Loom was first manufactured in 1937. It was a 4 shaft counterbalance loom and looks for all practical purposes like a Mira, the major differences being that it has two sets of treadles and an overhead set of pulleys to support the shafts. Dubbed the Double Loom 90″ in 1952 it was replaced by the Kebec 100″ loom in the mid-1960’s. A Fanny-like hinge was an added option beginning in 1980 along with a 120″ option, and in 1982 it was again refashioned into the Kebec II, which remains in production today. Its current price starts at $8,500+.
Yesterday I arose at 1:30 a.m. and drove six hours south to buy a 90″ Loom. I took my time. The roads were near-well deserted. I brought with me a sheet of plywood that I strapped to the deck of my truck to serve as both an extension of the bed, knowing that the loom would stick out over the end, as well as to protect the loom from the bed itself. I first laid out a tarp, and then a piece of construction weight plastic sheeting, wrapping it first in the plastic and then the tarp. I would have done so in spite of knowing that it was supposed to rain on my way home, which it did.
It cost $333.
Here is its page on this site: