Tag Archives: nails

Building A 45″ Raddle

Today I put together a raddle for my 45″ floor looms.  Our local cabinet shop had a 48″ long, 2″ x 2″ piece of clear maple.  My total cost was $28.00…list price for a Leclerc is $70…

DSC00031

I ripped the board in half, lengthwise – 2, 1″ x 2″ boards – and planed them.  Then I lightly penciled a line with a square down the entire length of the board and hash marked it at 1/2″ intervals.  I dimpled these hash marks with a nail.  I added a fence to my drill press and drilled out the holes that are a little smaller than the 3″ common nails.  The wood is not drilled all the way through…

DSC00032

Cutting off the heads of the nails the remaining stubs are sanded and smoothed.   The nails are lightly hammered into place.  The opposing block of wood is drilled with holes twice as large as the nails to ease fitting.  And the raddle is given its first treatment with boiled linseed oil…

DSC00035

The finished raddle…

DSC00034

Advertisements

Wool Picker: Failure And Success

Yesterday I finished a wool picker that utilized 3 1/2″ nails set at 90 degrees to the cards on which these were mounted.  While the opposing teeth were set closely, this did not work, but only seemed to roll the wool back and forth among the various sets.  I worked all day on this and went to bed disgusted.  Some of the wool pickers on the internet seemed to only have vertical barbs.  This doesn’t work…

DSC00006

Today I cut new wooden cards.  Then I used a 1″ grid from the internet to set out a pattern on it, including an offset grid at 1/2″.

DSC00011

In order to drill at an angle dimple the grid at each mark first…this will allow the angled drill bit to bite where you want it to.  Here’s my 45 degree template that I made up using scrap plywood/lumber and a small drill press.

DSC00010

This is the result on the wooden cards…

DSC00003

Top cards and bottom cards need to be this far apart if possible > <…

DSC00001

…I may have to adjust these a bit better, but they seemed to work well as is.  The nails are sharpened on a low-speed grinder/polisher.  They are very sharp.  And it worked well!

DSC00002

Here’s the machine at work…

There’s a lot of difference between the loft of picked wool (top) and unpicked wool (bottom)…

DSC00004

And there’s the dirt and dander left behind from picked wool/fibre as well….

DSC00009